Planar C3013T Manual do Utilizador descarregar pdf (Página 19)

Installing Memory

Figure 10

Do not remove the T-Bar or standoffs.

Each SO DIMM bank is wired in parallel and requires two modules. You can fill

one bank or both. But you should never put just one DIMM module in a bank:

the unit will malfunction.

To remove an SO DIMM module

1. Remove back housing as above.

2. Placing your hands on both sides of the T-Bar, gently open both side catches simultaneously

(apply pressure to the plastic part of the catch, not the metal spring).

3. The SO DIMM module will pop up.

4. Remove the SO DIMM module.

To install a SO DIMM module

1. Remove back panel as above.

2. Placing your hands on both sides of the T-Bar, gently insert the SO DIMM module into an

empty socket. Ensure correct orientation using the module notch located next to the contacts. In

Bank 0 the module orientation notch will face toward the processor. In Bank 1 the module ori-

entation notch will face away from the processor.

3. Push the module down gently until the side catches snap into place, coaxing them if

necessary.

Technical Note: The SO DIMM module will only insert one way into the socket; do not

force it. If you meet with resistance, check the orientation of the module.

8 Planar Clean Screen PC User’s Manual

SO DIMM bank 0

SO DIMM bank 1

CS Manual LAYOUT#1787 3/9/98 5:33 PM Page 8

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 59 60

Sem comentários

Planar C3013T Manual do Utilizador Página 19